Decided after going to a meeting at the Fablocker space on Thursday to get started on my RepRap. If I waited until I 'have' the spare time I'd never get it done.
Started with the visual guide for Prusa and setup my drill press and got out the Dremel to clean up the parts as I go.
I finished the frame (not fully aligned yet) and only had one issue while putting it together. My top vertex holes I made a little too close together when I drilled them, so I had to adjust the y axis brackets just a little to get them to go on without having to beat them into submission.
So I've got the frame assembled, next step is to square it and tighten everything down. Then it will be on to the X axis installation.